HP Color LaserJet 250-sheet Paper Trays
Showing 49–72 of 87 results
-
Top inner cover (black plastic) – Covers the back half of the pressure roller arms and springs
-
Paper pickup roller assembly – Includes the ‘D’ shaped rubber roller on a plastic shaft – Mounts in the lower center of the center frame assembly
$52.81 -
Paper pickup roller (‘D’ shaped)
$50.38 -
Grounding plate – Grounds the paper feed roller – Mounts towards the right end of the center frame assembly
-
Solenoid cover/magnetic shield – Mounts on the right end of the center frame assembly (over the pickup solenoid)
-
Mechanical sensor flag (black plastic) – For the paper feed sensor – Mounts on top of the center frame assembly
$50.38 -
Shaft mounted sensor flag (black plastic) – For the paper out sensor – Mounts on the paper pickup roller drive shaft
-
Feed roller assembly – Includes the metal shaft and two small rubber rollers – Feeds paper from the paper cassette (or tray three below) into the printer – Mounts on the top of the center frame in the base on the 250-sheet input tray assembly
$79.52 -
Front cover for the 250 sheet paper cassette tray (Blue) plastic – Has molded in paper loading instructions and a ‘2’ on the front
$152.50 -
Metal support cross-brace – Mounts on the top rear of the left and right support frame/cover assemblies – For the base on the 250-sheet input tray assembly
-
Left side frame/cover (Quartz Gray) plastic – Left side cover and input paper tray guide
-
Center support frame (black plastic) – Support structure for the paper pickup roller, feed roller, and paper sensors – Mounts to the top front of both of the support frame/cover assemblies
-
Pulley roller (accommodates one feed belt) – Small black roller approximately 1.59cm (5/8 inch) long with one ball type pulley
$235.15 -
Paper feed belt – Small black rubber belt approximately 1/8 inch wide with little ‘A’ shaped ribs on it
$50.38 -
Cross-member support – ‘L’ shaped bracket used to help support the camera (photo) memory card interface boards
-
Separation pad support – Pivoting ‘L’ shaped metal support frame (Does NOT include the separation pad assembly)
-
Right paper feed guide (small Black plastic arm)
-
Left paper feed guide (small Black plastic arm)
-
Sensor arm and flag – Activates the photosensor (Does NOT include the roller)
$98.23 -
Sensor assembly mounting holder
$50.38 -
Cover – For the engaging motor (PM704) – Mounts on the upper left side of the rear frame assembly
$50.38 -
Lock release shaft – Small shaft with locking tab – Does NOT include the lock release lever
-
Shipping stopper (bright orange plastic) – Helps to prevent damage to the paper tray by restricting the movement of the lift plate (Removed for normal use)
$132.46 -
Shaft bushing/retainer
$57.50