HP LaserJet 2000-sheet Paper Trays
Showing 1–24 of 143 results
-
Assy-Sub Pulley Drive Part SAM-JC93-01465A , JC93-01465A
-
HCI-Right Door Part SAM-JC90-01734A , JC90-01734A
-
HCI-Sub Pickup Part SAM-JC90-01727A , JC90-01727A
-
HCI-Sub Paper Side Right Part SAM-JC90-01723A , JC90-01723A
-
Bracket-Sensor Part SAM-JC81-07468A , JC81-07468A
-
Guide-Plate Post Upper Part SAM-JC61-04660A , JC61-04660A
-
Guide-Post Plate Part SAM-JC61-04659A , JC61-04659A
-
Connector-Main Electrical Part SAM-JC39-02600A , JC39-02600A
-
Motor-Feed Drive Part SAM-JC31-00033B , JC31-00033B
-
Tension spring – Used to dampen the maximum opening of the right door – Mounts between the right door strap cables and the front and rear inside walls of the tray assembly (two used)
-
Paper size guide – `T` shaped plastic structure with paper size indication label – Mounts to the top of the front side wall of the paper tray assembly
-
Microswitch for High Capacity Input unit – Detects if tray 4 is installed correctly – Located at top center of High Capacity Input unit
-
Door strap cable assembly – Wire cable with crimp lugs on each end – Does NOT include the spring – Limits the travel of the right pull-down door assembly (two used)
-
Rail latch – Square plastic tube with latching tabs – Mounts on the square rail that attaches to the bottom of the printer
-
Latch – Hook shaped plastic piece with shaft hole and recessed area for a dowel pin – Helps to hold the high capacity input tray to the printer (two used)
-
Sensor lever – Plastic lever with pivot hole towards one end – Activates the paper volume sensor – Mounts on the rear inside wall towards the printer
-
DRIVE-SUB PULLEY;X4300,NON-MD;
-
TAKEAWAY-HCF;JadeX4300;
-
HCF SUB-PICKUP;JadeX4300;
-
HCF SUB-PAPER SIDE R-JadeX4300
-
CSP-BRKT-SENSOR CLX-HCF102
-
MOTOR GEARED;18.5RPM,1.5N.M,24;
-
Caster wheel – (Four used)
$50.38 -
Screw – 6 mm Phillips head screw with attached washer
