Compaq Professional 5100 series
Showing 1–24 of 77 results
-
SPS-FEET
-
Front bezel assembly – Includes the front bezel, speaker grill, LED light pipe, power switch button, and button spring
-
PS/2 four-button mouse (Beach Gray) – Has three finger and one thumb switch buttons, `Compaq` logo, and 1.83m (6.0ft) cable with 6-pin mini-DIN connector
-
Power supply assembly (with cooling fan) – 90-264VAC input, 43-66Hz – Six DC outputs, 280 watts – For worldwide operation
$69.85 -
Riser (or backplane) board assembly – Vertical board with three PCI slots, one PCI/ISA shared slot, and one ISA slot – Plugs into the system processor board
$60.63 -
System board with tray – Main board in the bottom of the workstation – Does NOT include the processor or voltage regulator modules – Can use either 266MHz or 300MHz processor modules ONLY
-
Intel Pentium II processor module – 333MHz (Klamath, 66MHz front side bus, 512KB Level-2 cache, Slot 1) – Includes Black aluminum alloy finned heat sink assembly
-
Spaceball (3D pointing device) driver software on CD-ROM
-
16MB Memroy Module – To add additional memory to the ELSA GLoria-XL 3D graphis controller board
-
2.1GB Ultra SCSI-2 hard drive – 7,200 RPM, 3.5-inch form factor, 1.0-inch high
$160.20 -
STB MVP Dual Virge DX graphics daughter board – Upgrades the STB MVP Dual Virge DX graphics controller board by adding two more monitor outputs (via the base board output connector) for quad output – Has 4MB EDO RAM for each channel and 170MHz RAMDAC
-
Magellan Spacemouse (3D pointing device) driver software on CD-ROM
-
Tower stand – U-shaped plastic foot – Support foot for stabilizing the workstation for use in the tower position
-
Return Kit – Includes the shipping container and internal packaging – For returning the computer in the United States for repair
-
Professional Workstation 5100 maintenance and service guide
-
INACTIVE SPS-GDE MAINT & SVC Part 297744-001 , 297744-002
-
Professional Workstation 5100 illustrated parts map
-
Magellan Spacemouse (3D pointing device) – Mouse device with a cursor controller and nine programmable buttons – Includes an attached serial cable with a 9-pin D-subminiature connector
-
Spaceball (3D Input Device) – Mouse device with ball type power sensor and two user buttons (one on each side) – Includes an attached serial cable with a 9-pin D-subminiature connector
$233.12 -
Speaker and baffle assembly – Includes a 2.0-inch round speaker mounted in an elongated plastic case – Includes the connecting cable
$50.38 -
Heat sink bridge – C-shaped stainless steel bracket (approximately 0.8-inches high x 1.4-inches wide x 4.6-inches long) with locking fingers – Fastens between the processor heat sinks when two processor modules are installed
-
Drive cage assembly – Has two 3.5-inch third-height drive bays (one is used for the floppy drive, the other for a hard drive) next to two 5.25-inch half-height drive bays
-
Top cover assembly – U-shaped cover that includes the top and both sides
-
Tubeaxial fan assembly – 92mm x 92mm x 25mm thick – Has three wire 21.6cm (8.5-inch) long cable – 6.0V to 13.8VDC operating voltage, 26.5CFM
$60.63